The primary purpose of an ac electric power system is to move electric power from the sources of the electric power, the generators, to the consumers of the electric power, the loads, through the wires joining the two, the transmission and distribution system. Power systems come in a variety of sizes, ranging in size from those with a single small generator and perhaps a handful of loads to the gigantic.

IEEE Power Systems Projetcs 2017-18

S.No
Code
Title
Category
1
LMTVLSI01
Zonal Mitigation of Power Quality Using FACTS Devices for Provision of Differentiated Quality of Electricity Supply in Networks With Renewable Generation
VLSI 2017-2018
Abstract   
2
LMTVLSI02
Reactive power performance analysis of dish-Stirling solar thermal diesel hybrid energy system
VLSI 2017-2018
Abstract      
3
LMTVLSI03
High-Efficiency Modules With Passivated Emitter and Rear Solar CellsAn Analysis of Electrical and Optical Losses
VLSI 2017-2018
Abstract      
4
LMTVLSI04
Novel Quasi-Decentralized SMC-Based Frequency and Voltage Stability Enhancement Strategies Using Valve Position Control and FACTS Device
VLSI 2017-2018
Abstract      
5
LMTVLSI05
Computationally Efficient Adjustment of FACTS Set Points in DC Optimal Power Flow With Shift Factor Structure
VLSI 2017-2018
Abstract   
6
LMTVLSI06
Data-Mining-Based Intelligent Differential Relaying for Transmission Lines Including UPFC and Wind Farms
VLSI 2017-2018
Abstract   
7
LMTVLSI07
Robust fuzzy-sliding mode based UPFC controller for transient stability analysis in autonomous wind-diesel-PV hybrid system
VLSI 2017-2018
Abstract   
8
LMTVLSI08
Application of Transformer-Less UPFC for Interconnecting Two Synchronous AC Grids With Large Phase Difference
VLSI 2017-2018
Abstract   
9
LMTVLSI09
Modulation and Control of Transformer-less UPFC
VLSI 2017-2018
Abstract   
10
LMTVLSI10
Bidirectional Power Flow Control in a DC Micro grid Through a Switched-Capacitor Cell Hybrid DC-DC Converter
VLSI 2017-2018
Abstract   
11
LMTVLSI11
Hybrid Power Flow Controller Steady-State Modeling, Control, and Practical Application
VLSI 2017-2018
Abstract   
12
LMTVLSI12
Varying phase angle control in isolated bidirectional DC-DC converter for integrating battery storage and solar PV system in standalone mode
VLSI 2017-2018
Abstract   
13
LMTVLSI13
Finite-control-set model predictive control scheme of three-phase four-leg back-to-back converter-fed induction motor drive
VLSI 2017-2018
Abstract   
14
LMTVLSI14
Multi-topology-Mode Grid-Connected Inverter to Improve Comprehensive Performance of Renewable Energy Source Generation System
VLSI 2017-2018
Abstract   
15
LMTVLSI15
Synchronous Flux Weakening Control With Flux Linkage Prediction for Doubly-Fed Wind Power Generation Systems
VLSI 2017-2018
Abstract   
16
LMTVLSI16
A Novel Contra-Rotating Power Split Transmission System for Wind Power Generation and Its Dual MPPT Control Strategy
VLSI 2017-2018
Abstract   
17
LMTVLSI17
Damping torque analysis of power systems with DFIGs for wind power generation
VLSI 2017-2018
Abstract   
18
LMTVLSI18
IGDT based robust optimal utilization of wind power generation using coordinated flexibility resources
VLSI 2017-2018
Abstract   
19
LMTVLSI19
Ride through strategy of quasi-Z- source wind power generation system under the asymmetrical grid voltage fault n
VLSI 2017-2018
Abstract   
20
LMTVLSI20
Optimal reactive power dispatch: a review, and a new stochastic voltage stability constrained multi-objective model at the presence of uncertain wind power generation
VLSI 2017-2018
Abstract   
21
LMTVLSI21
Novel Power Smoothing and Generation Scheduling Strategies for a Hybrid Wind and Marine Current Turbine System
VLSI 2017-2018
Abstract   
22
LMTVLSI22
Low-Power Energy Generation Systems for Two-Phase PM Machine With Reduced-Switch-Count Controlled Switches
VLSI 2017-2018
Abstract